News Center


Closed cooling tower -- Wuxi Ma Xinte Machinery Manufacturing Co., Ltd.


Release time:

2023-09-28

Wuxi Ma Xinte Machinery Manufacturing Co., Ltd. is a professional manufacturer of cooling towers, with modern factories and advanced technology and production equipment. The company focuses on the production of closed cooling towers, open cooling towers, evaporative condensers and other process water cooling and gas condensation equipment. The MSTHB cross-flow closed cooling tower to be introduced here has the characteristics of low noise, not easy to scale, and convenient maintenance.

Wuxi Ma Xinte Machinery Manufacturing Co., Ltd. is a professional manufacturer of cooling towers, with modern factories and advanced technology and production equipment. The company focuses on the production of closed cooling towers, open cooling towers, evaporative condensers and other process water cooling and gas condensation equipment. The MSTHB cross-flow closed cooling tower to be introduced here has the characteristics of low noise, not easy to scale, and convenient maintenance.

1. working principle

The high-temperature working fluid enters the surface cooler, and the waste heat exchanges heat and mass with the falling spray water through the outer wall of the coil and vertically alternates with the dry and cold air fed into the side to form saturated hot and humid air. The heat is discharged by the top fan, and the water is blocked by the special structure of the dehydrator back to the collection tank for recycling. Different from the countercurrent type, the cross-flow type spray water first passes through the PVC filler pre-cooling, and its heat exchange effect is more obvious.

2. technical parameters

MSTHB Technical Parameters-Cross-flow Closed Cooling Tower Selection Table

Note: * The above models are standard models, and the fan, water pump and size will be adjusted according to actual parameters. Please refer to the actual scheme.

* Design working condition: the maximum design flow rate of red copper pipe is ≤ 450 m/h; The design wet bulb is ≤ 28 ℃, the dry bulb temperature is ≤ 31.5 ℃, the relative humidity is ≤ 85%, and the altitude is not more than 1000 (corresponding antifreeze protection is adopted in winter).
* If in doubt, please consult our customer representative.
 
3. product advantage


1) Low noise

PVC filler improves work efficiency while reducing water drop noise. The fan adopts low-speed wide-page aviation wing blades to reduce noise value.

2) not easy to scale

The temperature of the spray water can be controlled below the temperature that is easy to scale, and it flows smoothly through the surface of the heat exchange tube, forming a wet and complete coverage of the surface of the tube, effectively preventing scaling.

3) Convenient maintenance

Modular assembly for easy installation, disassembly and maintenance.
The internal space is equipped with maintenance access, and the top is equipped with maintenance guardrails and maintenance ladders, which are convenient for maintenance personnel to check and repair.
 
Wuxi Ma Xinte Machinery Manufacturing Co., Ltd. focuses on cooling tower manufacturing consultation telephone number: 13812276871